Pap2 is the most common & widely used
model available in the market.
50% of the mtnl/bsnl connections have Utstarcom UT300r2u modem.
Step By Step Configuration
1) Test your connection speed , latency & jitters at
testyourvoip.com
2) UT300r2u—LAN—->PAP2
UT300r2u—Usb—->Computer for internet.
**these settings are for when you are using pap2 with UT300r2u without any other external router.
3) Most connections work with PPPOE mode which you cud check in modem by going to 192.168.1.1. Ensure it work on pppoe which means automatic dialing.
4)When connected as shown in step 2 check whether
power & ethernet light is switched on.
If yes move to next step else goto to step 3(modem not configured properly)
5)Dial ****100# with the phone connected to pap2(any phone port). This is to find out Dhcp has been enabled or disabled.
If enabled,move to step 7 else step 6.
6)Now to enable it Dial ****101#. Enter 1 to enable.
7) Dial ****110# with the phone connected to pap2(any phone port). You will listen to the ip address of ur pap2
write it down.(# this is a temporary ip address so might or might not change everytime the router or pap2 is rebooted)
6) open ur browser and put in the ip address in browser.
Chenge the settings as required and save.
You will receive the dial tone.
Make a call